Whats New
     
Home Page

About Page

What's New Page

Contact Page

Favorite Links

Custom Page

Shopping Page Page

Catalog Page

 

Tips and Tactics


Alright here are some tactics:

1. Dont follow the pack- A lot of things people do is get what i call ftld (follow the leader disorder) they dont want to go off by themselves.  Most of the people with ftld are just scared of gettin shot.  You really shouldnt have more than one person per bunker b/c if they have a grenade all they gotta do is chunk it over there and yall are all dead most likely.  That is the first one.  Just go your own route but talk it over with your team.

2. Have your routes set- Some people get so caught up in the game that they forget about their routes.  That is one of the worst things that can happen because you dont want to run into friendly fire.  I know most of yall are sayin well im sure they can tell the difference but you really cant during a game.  So have your routes planned out first.

Here is a Tip:

1. Have handmotions- Instead of yellin out what to do motion it and if you cant get their attention whistle dont yell thats stupid.  When you yell it gives away your position and that is a no-no.  As soon as i get some handmotions ill post them.  Or if not handmotions get some cheap-o two way radios.

 

How about some more stuff to build

paintball gernade- (warning be very careful with this)                            Materials needed: A section of 1/8" rubber tubing about a foot long. (available at hose supply stores, medical supply stores, or chemistry supply stores.) Alternately, you could use a used SquadBuster.

A plastic clip tie
A large syringe ( if you don't have medical friends, you can find syringe like "emergency pumps for basketballs" in your local sporting goods store)
Some paint (either boiled down paintballs or children washable non-toxic paint
A pair of hemostats
Some ball bearings of slightly larger diameter than the tubing (you can find these in your hardware store)
Some cotter pins
Some alcohol
A rubber band (optional)
A target

1) Take the tubing, and cinch it down tight in the middle. If you want to make smaller; Little Betty type grenades, use only a six inch length and tie off one end of the tubing. If you're using an old SquadBuster, this is already done for you.
2) Fill the syringe with the paint mixture and inject it into one side of the tubing. Leave about 2 to 2.5 inches at the top empty.
3) Before you remove the syringe, crimp off the tubing below it with the hemostats. The filled section of tubing should look like a hotdog.
4) Lubricate one of the ball bearings with the alcohol and insert it into the tubing above the hemostats. If you still have the cap from the SquadBuster, just fold the tubing tip over and place the cap on.
5) Insert one of the cotter pins above the ball bearing, through the tubing. Or place the old SquadBuster pin through the hole in the cap. Leave the hemostat on until the alcohol dries. If you are making a Little Betty type grenade, you are now done.
6) Take the other empty side and repeat the process, except use the same cotter pin to hold both bearings in.
7) If you want the grenade to have maximum area coverage with a smaller paint coverage, simply leave as is. However, if you want maximum paint coverage put a weak rubber band around the grenade. The theory being this: When you pull the cotter pin out and throw the grenade, the non-banded kind will fall apart, pointing in two different directions. The banded kind will however, spray a greater amount of paint at a specific area. However, both types will spray in a radius because the release of pressure will make the hose tip wag around.
I have tested one of these, they do work, and expect about a 5 to 6 foot spray radius. Remember VERY IMPORTANT: get a good arc on these or try to throw it at something hard (like a bunker right behind your target) because you need to get enough pressure when it hits to push out the bearing (or knock off the cap). Conversely, after you have pulled the pin, DON'T squeeze the grenade or you will get very, very messy! Also, after you pull the pin, if you notice a small amount of leaking paint, throw it quickly or it will blow soon! And this should be the final result. I got this at http://www.geocities.com/pomanspaintball/new/grenade.html

 
   
 

Your Paintball